8AC126.60-1

General information
Module type ACOPOS plug-in module
B&R ID code 0xBD5A
Slot Slots 2, 3 and 4
Max. power consumption 4.4 W
Certifications
CE Yes
UKCA Yes
UL cULus E225616
Power conversion equipment
KC Yes
Encoder connection
Module-side connection 9-pin female DSUB
Status indicators UP/DN LEDs, BAT LED
Electrical isolation
Encoder - ACOPOS No
Encoder monitoring Yes
Max. encoder cable length 100 m
Depends on the cross section of the power supply wires in the encoder cable
Encoder power supply
Output voltage Typ. 12 V
Load capacity 300 mA
Protective measures
Overload-proof Yes
Short-circuit proof Yes
Synchronous serial interface
Signal transmission RS485
Baud rate 6.25 Mbit/s
Ambient conditions
Temperature
Operation
Nominal 5 to 40°C
Maximum 55°C
Storage -25 to 55°C
Transport -25 to 70°C
Relative humidity
Operation 5 to 85%
Storage 5 to 95%
Transport Max. 95% at 40°C
Materiálové číslo:
8AC126.60-1
Popis:
  • EnDat 2.2 encoder interface for installation in ACOPOS servo drives
  • Encoder monitoring
  • Embedded parameter chip when used with B&R motors
  • Backup battery possible
ACOPOS plug-in module, EnDat 2.2 encoder interface
Povinné příslušenství
EnDat 2.2 cables
8BCF0005.1221B-0 EnDat 2.2 cable, length 5 m, 4x 4x 0.14 mm² + 4x 0.35 mm², 12-pin female series 615 signal connector, 9-pin male DSUB servo connector, can be used in cable drag chains
8BCF0007.1221B-0 EnDat 2.2 cable, length 7 m, 4x 4x 0.14 mm² + 4x 0.35 mm², 12-pin female series 615 signal connector, 9-pin male DSUB servo connector, can be used in cable drag chains
8BCF0010.1221B-0 EnDat 2.2 cable, length 10 m, 4x 4x 0.14 mm² + 4x 0.35 mm², 12-pin female series 615 signal connector, 9-pin male DSUB servo connector, can be used in cable drag chains
8BCF0015.1221B-0 EnDat 2.2 cable, length 15 m, 4x 4x 0.14 mm² + 4x 0.35 mm², 12-pin female series 615 signal connector, 9-pin male DSUB servo connector, can be used in cable drag chains
8BCF0020.1221B-0 EnDat 2.2 cable, length 20 m, 4x 4x 0.14 mm² + 4x 0.35 mm², 12-pin female series 615 signal connector, 9-pin male DSUB servo connector, can be used in cable drag chains
8BCF0025.1221B-0 EnDat 2.2 cable, length 25 m, 4x 4x 0.14 mm² + 4x 0.35 mm², 12-pin female series 615 signal connector, 9-pin male DSUB servo connector, can be used in cable drag chains
Volitelné příslušenství
Battery Modules
8AXB000.0000-00 Accessory set for 8AC126.60-1 for encoder buffering consisting of: battery module for lithium battery 3.6 V

Vyberte prosím zemi a jazyk

B&R Logo